Research and Development

@article{Dimzon2016,

title = {Sampling and simultaneous determination of volatile per- and polyfluoroalkyl substances in wastewater treatment plant air and water},

author = {Ian Ken D. Dimzon and Joke Westerveld and Christoph Gremmel and Tobias Frömel and Thomas P. Knepper and Pim de Voogt},

url = {https://link.springer.com/article/10.1007/s00216-016-0072-1},

doi = {10.1007/s00216-016-0072-1},

year  = {2016},

date = {2016-11-25},

journal = {Analytical and Bioanalytical Chemistry},

volume = {409},

pages = {1935-1404},

abstract = {Volatile per- and polyfluoroalkyl substances (PFASs) are often used as precursors in the synthesis of nonvolatile PFASs. The volatile PFASs, which include the perfluoroalkyl iodides (PFAIs), fluorotelomer iodides (FTIs), fluorotelomer alcohols (FTOHs), fluorotelomer olefins (FTOs), fluorotelomer acrylates (FTACs), and fluorotelomer methacrylates (FTMACs), are often produced starting from the telomerization process. These volatile compounds can be present in the air and water environment and can be transformed into highly persistent perfluoroalkyl carboxylic acids. With the exception of FTOHs, which are well studied, the determination of other volatile PFASs is also of prime importance in studying the sources and fate of PFASs. In this study, a method was developed to determine representative precursor compounds that included PFAIs, FTIs, FTOs, FTACs, and FTMACs in wastewater treatment plant (WWTP) air and water samples. The sampling and sample preparation step involved the use of solid-phase extraction (SPE) cartridges with HLB™ material to enrich the analyte. Gas chromatography with mass spectrometry was employed for the detection and quantification of the analytes. Method validation results showed high linearity and sensitivity in the positive electron ionization-selected ion monitoring mode (+EI-SIM). The absolute instrumental limits of detection were in the range of 0.5 to 2 pg. The method detection limit (MDL) in air was 1 ng/m3 with the exception of the FTACs which could be only be detected at concentrations higher than 40 ng/m3. The MDL in water was 10 ng/L. Direct spiking of the cartridges and analyte introduction by volatilization from the glass surface onto the SPE material had recoveries between 86 and 100%. The volatile PFASs were shown to readily partition into the air rather than into water. Consequently, large losses in the amount of PFASs were observed when these were spiked into the water.},

keywords = {volatile PFAS and GC-MS and WWTP and influents and effluents and air},

pubstate = {published},

tppubtype = {article}

}